CSP Image    New South Remote Access Portal - (Watchguard)

NOTE: Watchguard is installed on the workstation and runs in the system tray. Once installed, you need not revisit this page. You may run Watchguard from the desktop or from the system tray.
(Unlike NetGear, it is not a browser based tunnel - Opening or closing the browser will not affect Watchguard).


Watchguard
Setup:

1. Click on this link http://ra.canforsouthernpine.com/Watchguard-Client and click run in the dialog box.

2. Run through the installer until complete.

3. Launch the Watchguard Client program (It will automatically open if the check box is checked on the final installation window).

4. There is one Watchguard Gateway Server or Portal for your use.

5. Define the Gateway Server/Portal. (Once entered and used, it will be stored for future use)

5a. Enter wg1.canforsouthernpine.com in the server address blank and click "Connect"

6. Enter your normal username and password and click Login.

All done! You’re connected.


NOTE:
Watchguard is installed on the workstation and runs in the system tray. Once intalled, you need not revisit this page. You may run Watchguard from the desktop or from the system tray.
(Unlike NetGear, it is not a browser based tunnel - Opening or closing the browser will not affect Watchguard).

Watchguard Use:

1. Simply click the Watchguard icon from the Start Menu or from the System Tray

2. Enter your New South Domain User ID and Password and Click Login

3. Remember to "Disconnect" your Watchguard client tunnel when you are finished with your work.